BlogHotel.orgAccueil | Créer un blog | Imprimer la page Imprimer | Blog hasard Au hasard | Chercher des blogs Rechercher | Entrer dans le chat du blog Chat | | Jeux Jeux | Adminitration et édition du Blog Manager

shinenewstop Accueil | Profil | Archives | Amis
shinenewstop

Industrial Perforated Plate Screens Irregularities Caused by Perforating Process26/11/2021
Industrial Perforated Plate Screens Irregularities Caused by Perforating Process Industrial perforated plate screens irregularities caused by perforating process includes breakaway on holes , burrs on holes, shearing burrs, wavy edge, edge bow, and missing holes.Get more news about Perforated Sheet Leveller,you can vist our website! Breakaway on holes When the punch has penetrated deeply into the metal plate from the punch side, material will begin to tear, or break away, mainly from the reverse side of the plate. It is not possible to predict the precise shape and dimensions of the breakaway zone, but its height t3 does not usually exceed two-thirds of the plate thickness t. The width of the breakaway wb is roughly related to the plate thickness t and does not usually exceed the nominal hole size w by an amount of 0.15 t.Burrs will occur during both the perforating and the cutting (shearing) operations. While burrs on holes occur on the reverse side of the plate only, shearing burrs may occur on either the punch side or the reverse side, depending on the manufacturing procedure adopted. Not more than 10% of the number of holes or 10% of the length of a cut edge of a perforated metal plate shall have burr heights in excess of the values stated in table 1.Stresses during perforation can distort the plate and cause variations in flatness in the margin areas, producing a so-called "wavy edge", particularly if the margins on opposite sides are greater than the plate thickness f + 0.5p. Stresses during perforation and subsequent roller levelling processes can distort the plate, producing curving of the edges (edge bow/camber), particularly if the longitudinal margins e1 and e2 are unequal and parallel to the direction of perforation. Edge bow is defined as the greatest deviation h of the edge from a straight line extending over the length of the concave side and shall be measured with the aid of a straightedge of sufficient length having a scale graduated in millimetres. The maximum permissible edge bow shall be agreed before ordering.Punches may break during the perforation process and fail to perforate in certain positions. The number of holes missed for this reason should not exceed 5% of the total number of holes in a perforated plate. When a multitool punch is used, it may not be possible to complete the pattern of perforations. For example, to minimize tool damage, punches of diameter less than 5 mm are usually spaced wider apart than the pitches of the holes. This arrangement, however, unavoidably results in missing holes in one or more rows at both ends of the plate (incomplete rows).
Poster un Commentaire

Entry 120 of 2912
Précédent | Suivant

Blog suivant >> Signaler un abus?Haut de page