BlogHotel.orgAccueil | Créer un blog | Imprimer la page Imprimer | Blog hasard Au hasard | Chercher des blogs Rechercher | Entrer dans le chat du blog Chat | | Jeux Jeux | Adminitration et édition du Blog Manager

shinenewstop Accueil | Profil | Archives | Amis
shinenewstop

Cutting and Engraving Different Line Weights26/9/2022
Cutting and Engraving Different Line Weights If you're vector cutting items and set the line width to "hairline" in Corel, you should have no problem cutting. But what about other line weights? Which ones engrave and which ones will cut? And what about resolution? How do all these variables effect the end result?Get more news about laser cutting line,you can vist our website! Different line weights will cut and engrave at different widths and resolutions. Here's a handy guide for both the Legend Elite Series and the Zing Starter Series that illustrates what lines will cut and engrave and the resolutions to use to get your desired result. First, it's important to know that very thin lines will not raster engrave, and the definition of “thin” varies depending on the resolution being used. The first table below illustrates which line weights will raster at different resolutions when in Raster or Combined mode on the Legend Elite Series (Epilog Mini 18, Mini 24, Helix and Legend 36EXT). The rectangle below has a line weight of 0.001 inch. It will not raster engrave at any resolution (see the charts above). If you send just this box to the laser in Raster mode and try to run the it, the laser will beep once and register the job as complete because the line is too small to be recognized as an engraving line. Vector mode is used to mark or make a thin line drawing. The vector speed, power and frequency bars will be enabled when you have selected Vector under Job Type in the Dashboard. Very thin lines are used to define vector cutting. Again, the definition of "thin" varies depending on the resolution being used. The following table shows which line weights will vector cut at different resolutions when in Vector or Combined mode. As a general rule, most users set their vector line weights to .001 inch. Below are tables that indicate what line weights will vector cut at different resolutions on both the Legend Elite Series and Zing Starter Series. For ease of use, we recommend that you set your vector lines to 0.001 or 0.003 inches. These line weights are the most commonly used in most software applications and, as you gain experience, setting them will become second nature. As you can see from the tables above, these line weights will vector cut at all resolutions.
Poster un Commentaire

Entry 120 of 3161
Précédent | Suivant

Blog suivant >> Signaler un abus?Haut de page