|5V/12V 2 Channel Relay Board Module Optocoupler LED for Arduino PiC ARM AVR
It is a Small and easy to portable ultra bright Mini LED light.compact and light weigh.can be use on both desk and bedside table, or to go out. feeling so convenient. its soft shade, avoid the direct LED light shine, more effective protection of eyesight. its flexible body Suitable for all occasions,Compatible with power,Can be connected to the PC USB port.Get more news about Stationalry Led Pis,you can vist our website!
Features:The module uses high-quality relay, the maximum load of the normally open interface: AC 250V/10A, DC 30V/10A.Using patch optocoupler isolation, strong driving ability, stable performance; trigger current 5mA.The module working voltage is available in 5V, 9, 12V, 24V.The module can be triggered by a jumper to set a high level or a low level.Fault-tolerant design, even if the control line is broken, the relay will not move.Power indicator (green), relay status indicator (red).
The interface design is user-friendly, all interfaces can be directly connected through the terminal block, very convenient.Specification:Module Size:50 x 41 x 18.5mm / 1.97 x 1.61 x 0.73inHole Diameter: 3.1mm/0.12inHole Interval Distance:44.5 x 35.5mm / 1.75 x 1.4inWiring Diagram:DC+: Connect the positive pole of the (the voltage is required by the relay, there are 5V.9V.12V and 24V selection).DC-: connected to the negative pole of the .IN1:1 signal signal trigger terminal, you can set the high or low level control relay to pull in.IN2: 2 channel signal trigger terminal, you can set the high or low level control relay to pull in.Relay output:NO1: 1 channel relay normally open interface, the relay is suspended before the suction, after the suction and short circuit with COM1.COM1:1 channel relay common interface.
NC1: 1 channel relay normally closed interface, short circuit connection with COM1 before the relay is closed, suspended after suction.NO2: 2 channel relay normally open interface, the relay is suspended before the suction, after the suction and short circuit with COM2.COM2: 2 channel relay common interface.NC2: 2-channel relay normally closed interface, short-circuit with COM2 before the relay is closed, and float after the suction.High and low trigger selection:1. S1 is a high-low trigger selection for 1 relay;2. S2 is the high and low level trigger selection of 2 relays.3 com is shorted with low, the corresponding relay is triggered by low level, and when com is shorted with high terminal, it is triggered by high level.Package List:1 x Module|